Rope Fuel Sensor – 3 Foot Sensing cable

Rope Fuel Sensor – 3 Foot Sensing cable

$703.00

Add to Quote

Description

Rope Fuel Sensor

The Rope Fuel sensor detects the presence of liquid hydrocarbon fuels at any point along its length

This sensor is suited to locations that contain fuel storage tanks or fuel transfer stations and is especially ideal for remote locations that use diesel fuel generators.

  • Optional Lengths Available

Additional information

Option

ropeFuel Sensor

This sensor is suited to locations that contain fuel storage tanks or fuel transfer stations and is especially ideal for remote locations that use diesel fuel generators. The AKCP ropeFuel sensor is a rope-type leak detector that connects to any AKCP sensorProbe or securityProbe RJ-45 Intelligent Sensor Ports and facilitates the detection of fuel and other liquids.

The ropeFuel sensor detects the presence of liquid hydrocarbon fuels at any point along its length. Installed with the AKCP sensor module, the sensor detects the liquid, triggers an alarm, and pinpoints the location of a leak within a meter, or a foot. Typically this sensor can detect:

  • Gasoline
  • Diesel #1
  • Jet AB58
  • JP-457
  • Kerosene

As this sensor is a rope type it is perfect for lying beneath fuel tanks, usually found being used with diesel generators in remote locations where early warning of fuel leakage or theft is vital to maintaining the power supply, either of a UPS or as the main power source.

The AKCP ropeFuel sensor in most cases is for single usage only and must be replaced after exposure to hydrocarbon liquids.

Specifications

Specifications

Measurement Range Wet or Dry
Sensor Type Open/Closed contact input switch
Measurement Rate Multiple readings every second
  Capable of detecting the presence of fuel and oil at a specific location within 1 meter, or 1 foot along the length of the sensing rope
Response Time Typical response time at 20°C (68°F)
• Gasoline : 2-12 minutes (depending on the grade and type)
• Diesel #1 : 60 minutes
• Jet AB58 : 50 – 70 minutes
• JP-457 : 15 – 70 minutes
• Kerosene : 47 minutes
Nonresettable Must be replaced after exposure to hydrocarbon liquids
Indication LED for Status
Operating Temperature -20 °C~60 °C
4 °F~140 °F
Pull Force Limit Not to exceed 50 lb
Bend Radius 2 in. (50 mm) minimum
Pressure Loads greater than 20 lb (9 kg) per linear inch at 20°C (68°F) may immediately trigger an alarm
   
Interface  
Communications Cable RJ-45 jack to sensor using UTP Cat 5 wire
Communications Cable Max. length The FuelRope Sensor can be extended from the RJ-45 Intelligent Sensor ports on the base units up to 100 feet, or 30 meters using standard CAT5/6 LAN cable.

Comes fully assembled and includes the rope portion that is the liquid sensing cable, the non-sensing leader cable (from the rope to the sensing module) and the main sensing module. Also includes a 5 foot CAT5 extension cable
Sensing Rope Cable can be pre-ordered from a 1 meter minimum to any custom run length of up to 5 meters.

Non-sensing cable comes in a standard 20 feet run length.

Power Source Powered by the controller unit. No additional power needed
  Full autosense including disconnect alarm
Power Consumption Typical 125 mWatt, 25 mA
Dimensions 56 x 55 x 33.3 mm
Mounting DIN rail mounting
Screw mounting
Cable Diameter 0.28 in. (7 mm) nominal.
Important Note * The AKCP ropeFuel sensor in most cases is for single usage only and must be replaced after exposure to hydrocarbon liquids.
* AKCP does not recommend the ropeFuel Sensor to be placed on a conductive surface. 
Sensor count 1